IP Series Surge Protector

STR201EP

STR201EP

1-CH Network Signal Surge & Power Protector
Features
●Single Channel Network Signal+Power Surge Protector
●Standard:IEC61643-21:2000
●protect 12V power and video at the same time
●Multilevel protection: Overvoltage protect ,large Flow capacity
   Low limiting voltage, faster Response,less Insertion loss
●Ground connection: directly to ground
●Nice Design, mini size,easy to installation
Specifications:
Temperature:-40℃～70℃；
Relative humidity：≤95%；
Atmospheric pressure：70kPa～106 kPa.
Model STR201EP12V
  Network unit Power Unit
Nominal working voltage (Un) 5V 12v
Max continuous operating voltage (Uc) 6V 15v
Max discharge current Imax(8/20ms) 1、2、3、6-PE 2KA 10KA
SE-PE 5KA
Protection level (Up)10/700/ms 1-2 ＜20V 30V
3-6 ＜20V
Insulation resistance MΩ ≤0.4  
Insertion lossdB dB ≤0.5
Bandwidth FG (0.3~100)M  
Transmission rate Vs 100 M  
Response time Ta ≤1ns ≤25ns
Protection level IP20
Dimensions 92×66×30mm
Case Material aluminum
Lines of protection 2 pairs（1-2、3-6） Two lever Protection
Interface type RJ45 terminals

































Installations, Use and Maintenance:   

1 Installation steps
*Before connecting the protector to the system, Make sure
 check grounding resistance and conform to the criteria with
 the requirements;
*Connect the protector to the front of the device firmly.
*Use the short and thick grounding lines as possible as you can
 to connect with the Earth-termination system.
2 Note:
*There are IN and OUT icons marked on the protector, and
  the OUT port should be connected with the protected device,
  please don’t make mistake. Or it will cause damage to the
  protector, and also the device can’t be protected as expect.
*Due to sockets connected interface factors caused the loss of
  poor, should be replace the protector or maintenance.
*Users Can’t removes the fasteners part of the device, in order
  to avoiding damage and affect the normal work.
3 Protector examination
*Protector no needs special maintenance, in case the protector
  shocked by high voltage, the Led lights will power off, it means
  need to replace or maintain the protectors
*Use the Multi-meter with "Ω × 1" range to measure the protector’s
  resistance, the value should be around 0 Ω ; If not, protector need to
  be replaced.
*Use the Multi-meter with "Ω × 10K" range to measure the middle
  line to earth-ground resistance, the value will be around 400KΩ, if not ,
  need to replace the protector.



Product appearance and the installation instructions:

 
 





 
 
 
 
 
 
 
 
 
 
 
 
 
 

Class Date Title Download